Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

routing protocols

If I have a router with 2 interfaces, say 192.1.1.1 and 172.1.1.1, both /24 mask and I advertise these in eigrp, first of all what gets advertised, is it the interface and network, and also If I had a network statement in eigrp saying network 10.0.0.0 but didnt have any interfaces on this address would it advertise the network ?

thanks

2 REPLIES
Green

Re: routing protocols

Carl .... check out this link; it's to Cisco Internetworking Guide Online. The equivelant book is many inches thick.

The online version is broken down into nice short, easy-to-read segments, covering all aspects of basic networking and internetworking.

http://www.cisco.com/univercd/cc/td/doc/cisintwk/ito_doc/index.htm

It will explain everything ....

Good Luck

Scott

New Member

Re: routing protocols

For the network 10.0.0.0 to be avertise, the network have to appear in routing table as direct connected.One interface have to get ip address on this network .

http://www.cisco.com/en/US/products/sw/iosswrel/ps5187/products_command_reference_chapter09186a008017d02a.html#wp1040780

Regards.

111
Views
3
Helpful
2
Replies