Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

SYSLOG ???!!!!!!

hi all,

I am aware i can set the router to send messages to a syslog server, by using the 'log' keyword after my ACL statement.

I am wondering and want to know what other parameters i can observe with a syslog server.

Also can you point me somewhere with more info on the subject ??

Thanks,

George

2 REPLIES

Re: SYSLOG ???!!!!!!

Hi! George

You can set the severity level of the messages to control the type of messages you want to receive on your syslog server. The severity level varies from 0 to 7, with 0 being the highest severity level. You can also use the time stamp service to help you better in analysing the logs.

For more info on how to configure your syslog you can refer the following link -->

http://www.cisco.com/en/US/products/hw/switches/ps628/products_configuration_guide_chapter09186a00804762a4.html#wp1031557

Hope that helps.

Please rate the post if it does.

Regards,

AbhisheK

105
Views
0
Helpful
2
Replies