Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Transceiver Connection

Hi!

I?m connecting a Metrobility media converter (mtrj45-rj45 100 mbps) with a cisco 4503. When I ping the host 192.168.1.6 in the converter i just received timeout.

my config is very simple:

---------------

interface Vlan1

ip address 192.168.1.254 255.255.255.0

interface FastEthernet2/1

switchport access vlan 2

switchport mode access

speed 100

duplex full

--------------

C4k#sh mac-address-table

Unicast Entries

vlan mac address type protocols port

-------+---------------+--------+---------------------+--------------------

1 0019.55f2.c83f static ip,ipx,assigned,other Switch

2 000e.0cb7.a5e6 dynamic ip,ipx,other FastEthernet2/6

2 0019.55f2.c83f static ip,ipx,assigned,other Switch

2 0060.e0c0.0dd5 dynamic ip,ipx,other FastEthernet2/2

2 0060.e0c0.0e74 dynamic ip,ipx,other FastEthernet2/3

2 4000.0000.0006 dynamic ip,other FastEthernet2/1

C4k#sh arp

Protocol Address Age (min) Hardware Addr Type Interface

Internet 192.168.1.106 1 0060.e0c0.0dd5 ARPA Vlan1

Internet 192.168.1.254 - 0019.55f2.c83f ARPA Vlan1

C4k#

The converter is connected in the port fa2/1.

Please help me.

Thanks in Advanced.

1 REPLY
Silver

Re: Transceiver Connection

You have the interface FE2/1 in VLAN 2 but you do not show any IP layer 3 for VLAN 2. Try placing the interface in VLAN 1 and see what happens....Good Luck....

254
Views
0
Helpful
1
Replies