In almost all scenarios, its recommended to have 'dot1q' encapsulation and a static trunk config 'switchport mode trunk'. Matching the native VLAN on both sides is required and will be VLAN1 by default.
When configuring trunks, you should be mindful of VTP, trunk and STP states. Reviewing the following for mismatches between your Cat6K will help:
- show vtp status
- show interfaces trunk
- show spanning-tree
In terms of HSRP, it is also recommended to run HSRP active in the same location as STP Root to avoid any asynchronous routing problems.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.