Our ISP turned up our T1 today. For whatever reason I told them that I would provide the router and configure it myself. Now that I have been staring at this all day I realize I have no clue where to start. Here is what I have: (IPs have been changed for security)
Qwest serial = 10.100.100.57/30
my serial = 10.100.100.58/30
usable IP block: 10.10.10.224/29
dns = 188.8.131.52
eth 1private lan = 192.168.1.254/24
I configured Serial0 with 10.100.100.58 and setup NAT to my private LAN and that all worked great. But what I am needing to do is place 2 pieces of hardware on the public LAN using the 10.10.10.xxx address assigned to me. I cannot get these machines to do anything on ther Internet. I have bridged the ser0 and eth0, I have tried routing, i have sat and stared. I'm at a loss. Any help will be appreciated.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...