What is the correct confreg value for a normally operating 831?
I bought this router used on ebay and when it arrived, its nvram was not cleared from its old environment. I had to use the password recovery technique but, because I did not have the old password, I could not see waht the old confreg value was. This site told me it would be 0x100 or 0x2100. I took a guess at 0x100 but, the router cold starts to rommon. I can get it to boot to the flash image by running confreg at the rommon prompt but, I would like to set the correct confreg value so that it always boots from the ios on flash. I dont want to guess anymore as I run the risk of breaking the router.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...