Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

WIC-1DSU-T1

Hi,

I'm putting together a CCNA/CCNP lab and I have two 1720's with WIC-1DSU-T1 interface cards. Can I connect the two 1720's with the WIC-1DSU-T1 interfaces like you would with serial ports? Do I need an ethernet cable with any special pinouts? Thanks.

Riley

3 REPLIES

Re: WIC-1DSU-T1

Hi Martin

As per the cable specs its general 1,2 & 4,5 combination which carries both Tx/Rx signals.

You can try connecting 1,2/4,5 on one end and reversing the same at the other end.

http://www.cisco.com/en/US/products/hw/routers/ps214/products_tech_note09186a00801f5d89.shtml

for config assistance do refer the below link..

http://www.cisco.com/en/US/products/hw/modules/ps3129/products_tech_note09186a00800b1501.shtml

regds

Re: WIC-1DSU-T1

Hi,

Agree with Edwin, i think that i've tried this before, but make sure that one of the 2 ends is supplying the clocking using the "service-module t1 clock source internal" command, and the other having "service-module t1 clock source line", please check this document:

http://www.cisco.com/en/US/products/hw/routers/ps233/products_tech_note09186a00800a3f09.shtml#command

HTH,

Mohammed Mahmoud.

Community Member

Re: WIC-1DSU-T1

Yes you can do this. I do this in my home lab to simulate a WAN T-1 connection. You will been to make a "T-1 crossover cable".

http://www.voip-info.org/wiki/view/crossover+T1+cable

Regards,

Brandon

167
Views
0
Helpful
3
Replies
CreatePlease to create content