I have two modems that are connected to a gigabit switch in the basement with cat 5e hardwired connections going to 15 rooms in a house. I have a wrvs4400n that I would like to connect to one of these hardwired connections. Is this possible? I think the modems also act as routers.
If your modem also acting as NAT device its good practice to not to double NAT with another NAT device or router cause it make problems and inconsistencey between two NAT tables. configure wireless router to be used as access point.
The modem was also acting as an NAT device. It is issued by Time Warner Cable and I called them and had them turn the modem into bridge mode so that it no longer had wireless enabled. I am trying to configure a Cisco WRVS4400n to be the router and run access points off of it but the download speeds attained when connecting through wireless are disappointing. I am currently paying for 50mbps of internet and only receiving download speeds of around 10mbps and I am wirelessly testing right next to the router. Do you have any advice on where to go next?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...