Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Wireless Network signal

I have set up and configured a basic WLAN in my home, the problem is that when i try to connect i keep getting low signal and then kiked of the network when it gets too low even though i could be sitting right infront on the box is there anything i can do to bosst the siganl

1 ACCEPTED SOLUTION

Accepted Solutions

Re: Wireless Network signal

Hi

If you are trying to use the client just in front of the AP, then I suspect a hardware failure in either AP or client.

The possible solution is to replace each and see.Contact your vendor.

Regards

JD

4 REPLIES

Re: Wireless Network signal

Hi

(1)Please check the antenna's pigtail.It may have been detached from the antenna.

(2)Pls give the name of equipments you are using.The AP and the client.

(3)Are you using internal built in card or an external PCMCIA card?

Regards

JD

New Member

Re: Wireless Network signal

Hi JD the antenna is fine i check that today the equipment is belkin 54g wirless cable router and im using an external pci card to recive the signal

Re: Wireless Network signal

Hi

If you are trying to use the client just in front of the AP, then I suspect a hardware failure in either AP or client.

The possible solution is to replace each and see.Contact your vendor.

Regards

JD

New Member

Re: Wireless Network signal

Turns out when i took the AP back and i got a new one it was fine thanks for your feedback

172
Views
0
Helpful
4
Replies
CreatePlease login to create content