Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

xmodem issue

I have to use xmodem to recover IOS for switch 3750 because the current ios was lost.

when i tried to type: copy xmodem: flash:c3750-ipbasek9-mz.122-35.SE5.bin

i got "Begin the Xmodem or Xmodem-1K transfer now...". So I began send file with xmodem, I got the error prompt "Xmodem operation was canceled by remote peer". I also could not finish the file transfer.

Please help me and give any advice, thx a lot!

3 REPLIES
Community Member

Re: xmodem issue

Hi,

Could you please check you hyperterminal settings once.

Also go though this link..

http://www.cisco.com/en/US/products/hw/routers/ps259/products_tech_note09186a008015bfac.shtml#proc_3600

HTH

Inayath.

Community Member

xmodem issue

dear 

write this  " flash_init"   , then do the transfer to Xmodem ............... the error will be solve,

xmodem issue

Hi.

The terminal is not ready to copy the file, either the flash isn't ready or there's not enough space, like Rawa said, from rommon type flash_init to get it ready.

And second: make sure there's enough space in flash, dir flash: to check free space.

Regards.

Wilson B

4210
Views
10
Helpful
3
Replies
CreatePlease to create content