When a client connects to the wireless network it shows that the 1010 light weight access point is still WEP enabled. The reason I think this is because in the 2006 Wireless LAN Controller under Clients > Detail
WEP state = WEP enable.
I have WPA/802.11i checked for the WLAN and also WPA/802.11i checked for Trusted APs. I am not sure why it still shows that WEP is enabled?
I think WEP is still enabled on the WLAN controller. If you have enabled the WPA for the APs i guess the configuration is not saved on the controller. Try redoing the configuration and save it and check again. It should work.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...