I just recieved in the mail an aironet 1042n ap. It was assigned an ip of 192.168.1.254 by my router. When I attempt to connect it prompts for a password and states the default username and password is admin and 1234. It will not except this, or Cicso and Cisco, or cisco and cisco. Does this mean it's doa? Any ideas? Also does this require a wlan controller?
I am logging in on port 80 through chrome not sure if browser type matters. Also I am on a macbook if that effects anything. and admin/Cisco does not work. Thanks for your response, I need all the help I can get.
I will also go ahead and layout the network for you. SMC8014(cable Modem) -> Linksys E4200(Router) -> Cisco SLM2024T-NA(Switch) -> Telesync Switch -> 1042n
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...