Good suggestions all, I did add a helper address to the AP's subinterface. However, this vlan is a guest network with only Layer 2 access. There are no L3 interfaces except on the AP's subinterfaces and PIX which is its gateway and DHCP server. Oddly enough if I statically set the IP's and Gateway I can ping the gateway and other users in this vlan. But still no DHCP...Any other suggestions?
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...