Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

1131 AG VLAN using CLI?

Hi- I was wondering if there is a way to create vlan(s) using the command line instead of the Web interface. Example: If I used the Web int. I logged in, services, VLAN, New and add the vlan id, name and enable Radio0-802.11G and 11A.

Can I accomplished the same using CLI?

Thank you in advance for your replies.

Cheers!

Can I acomplished the same using CLI?

Thank you in advance for your replies.

Cheers!

2 REPLIES
Hall of Fame Super Red

Re: 1131 AG VLAN using CLI?

Hi Mauricio,

Have a look at the following (adding VLAN 10);

AP# configure terminal

Enter configuration commands, one per line. End with CNTL/Z.

AP(config)# interface Dot11Radio0.10

AP(config-subif)# encapsulation dot1Q 10

AP(config-subif)# interface FastEthernet0.10

AP(config-subif)# encapsulation dot1Q 10

AP(config-subif)# end

AP# write memory

From this good doc that has GUI and CLI commands;

http://www.cisco.com/en/US/products/hw/wireless/ps4570/products_configuration_example09186a00801d0815.shtml#apconfig

Hope this helps!

Rob

Please remember to rate helpful posts.....

New Member

Re: 1131 AG VLAN using CLI?

Thanks Rob, excellent info and link....

Cheers!

320
Views
5
Helpful
2
Replies