Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

1131 AP Shows as having "other" antenna in the WCS

I just installed 5 lightweight 1131 ap's, two of them show up as having " other " as the antenna type in my WCS , the others show as having Ajax-Omni. They all have the same code and were installed at the same time. Also I can't get a het map profile from the " other " listed AP's. Can anyone help?

Thanks

Bill

1 REPLY

Re: 1131 AP Shows as having "other" antenna in the WCS

1. You can go to Monitor Map ---> Campus ---> Select Building ---> Select Floor ---> From the drop down menu select command, choose "Position AP" and Go .

2. Click on the problematic AP's 1131 and select the correct Antenna type as being "AJAX-OMNI" which the image should match for AIR-LAP1131AG-A-K9.

3. Click Save and the heat map should start to populate.

4. From Floor Settings, select Access Points --> Protocol "802.11b/g/n" or 802.11a/n but not both. It's has to be one or the other else the heat maps will not display.

5. From Floor Settings ---> AP Heatmaps --> Contributing APs, Select ALL the APs and OK.

-nael

439
Views
0
Helpful
1
Replies