Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

1200 AP as Site Survey Tool (changes to repeater mode)

I am trying to use a AIR-AP1220B-A-K9 for a site survey. There is no LAN access for the AP's yet, so the AP does not get a Link. Because of that, the AP tries to switch to repeater mode, and so I cannot associate to it.

I've looked all through the web interface and the CLI through the serial interface, and can't find a way to prevent repeater mode.

I'm sure there's a way, I just haven't found it yet.

1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Re: 1200 AP as Site Survey Tool (changes to repeater mode)

Go to Ethernet Hardware

in the field 'Loss of Backbone Connectivity Action:' change teh dropdown box to 'No Action'

For details go to http://www.cisco.com/warp/public/779/smbiz/prodconfig/help/eag/air/ap3xx/SetHwEthernet.shm.htm

1 REPLY
New Member

Re: 1200 AP as Site Survey Tool (changes to repeater mode)

Go to Ethernet Hardware

in the field 'Loss of Backbone Connectivity Action:' change teh dropdown box to 'No Action'

For details go to http://www.cisco.com/warp/public/779/smbiz/prodconfig/help/eag/air/ap3xx/SetHwEthernet.shm.htm

271
Views
0
Helpful
1
Replies
CreatePlease to create content