I have a linksys wireless WRT54G setup as follows:
Static IP Internal: 192.168.1.1
Static IP Internet: 10.0.0.2
My device, a desktop, is setup as follows:
Static IP: 192.168.1.100
My AP is setup as follows:
Static IP: 10.0.0.1
From my PC I can ping the internal and external addresses on the linksys but cannot reach the AP (a 1231). I have tried wireless and hardwired connections from the PC to the linksys. I believe I saw the Linksys talk to the AP one time only.
I have attached an MS-Word Doc with a drawing, including some settings, of my test-bed as it appears now. This is setup in a lab, but I need to deploy soon.
I am using the Linksys as a collection point in one building to network a number of hard wired and wirerless devices (about 10). Is there a more "standard" configuration that might be better.
I know I still need to work on the other side, but am trying to get this link going first.
I was also wondering about mounting the WAP outdoors is this recommended or feasible? Not 100% necessary, but if I can place this outdoors I believe I can get a stronger connection...
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...