Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

1240AG AP vty acl problem

All,

I have fat fingered an ACL on my VTY for an Autonomous 1240AG AP. So I am unable to SSH/telnet into the AP. I can however still HTTP into it. Is there a way to remove the VTY ACL from the web interface? or do I have to rest it?

Thanks for your help

Dan

Everyone's tags (4)
4 REPLIES

Re: 1240AG AP vty acl problem

If you have console access do it.

If you did not save acl config you can reload the ap.

Otherwise, I am not aware about any other way except resetting the config.

Amjad

Rating useful replies is more useful than saying "Thank you"
New Member

1240AG AP vty acl problem

Hi Amiad

I figured it out. From the web interface if you go to System Software> System Configuration> Show tech-support> command.. you can add cli commands from there.

Thanks

Dan

Re: 1240AG AP vty acl problem

Thank you.

I almost never used gui so don't know much about it :")

Sent from Cisco Technical Support iPad App

Rating useful replies is more useful than saying "Thank you"
Bronze

1240AG AP vty acl problem

Hi,

If you still have access to the GUI (http) of the unit you can use the command http://AP ipaddress/exec and this will give you the option to go in and click on exce and run cli commands via the GUI.

Example:

xx.xxx.xx.xxx/level/exec

279
Views
0
Helpful
4
Replies
CreatePlease login to create content