Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

1240ag Bridge Issue

I have 2 1240ag's 1 in root bridge mode and the other setup as workgroup bridge.  I am bridging the main building with another building.  It is working, but I can only ping from the wgb location.

2 REPLIES
New Member

Re: 1240ag Bridge Issue

Hi, if they are associated they have to work like this, don't you have some issues with firewall or some thing like that? if not, can you post the config of the two ap's and the show dot11 associations for both?

Best Regards,

Milton Tizoc.

Hall of Fame Super Silver

Re: 1240ag Bridge Issue

You should try to setup one end as an access point and the other as a WGB.  Or else just do root-bridge to non-bridge if the remote end is going to be connected to a switch.  If you do the later, you can do the bridge link on one band and setup the other band for wireless access also.

-Scott
*** Please rate helpful posts ***
426
Views
0
Helpful
2
Replies
CreatePlease login to create content