06-11-2010 02:55 AM - edited 07-03-2021 06:52 PM
I am trying to configure a
1242AG with 2 Vlans, Guest and Admin - there is an example paper by Cisco showing just this scenario but it doesn appear to work- I was convinced the configuration is correct but the users PC cannot see either SSIDs - Guest is set to WEP and Admin is set to WPA2 TKIP - is there any way I can show that the 1242 is transmitting ?
many thanks
Solved! Go to Solution.
06-11-2010 08:36 AM
remove from the global config
dot11 mbssid
And under interface interface Dot11Radio0
Add
mbssid
and change to
station-role root
And test again
06-11-2010 08:13 AM
Post your config - or the url to the article.
06-11-2010 08:30 AM
06-11-2010 08:36 AM
remove from the global config
dot11 mbssid
And under interface interface Dot11Radio0
Add
mbssid
and change to
station-role root
And test again
06-11-2010 09:18 AM
Andrew -
apologies for the rating - I tried to give it maximum
but for some reason only got 4 star !!
Many thanks for your help
regards
Keith
06-11-2010 10:21 AM
Keith - no problem, thanks for the rating anyway - appreciated.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: