Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

1242AP how to check signal strength

I have a 1242 set up as a bridge tied to a solid dish. About 3 miles away I have 3 yagis set up as a non bridge working fine. I set a forth yagi say 800 ft away from a working yagi and the siginal works for a few minutes and then shuts down so I mounted a 50 ft. tower same problem so i replaced the yagi with a solid dish yesterday and my connection lasted the day and this morning it was down again.

There has to be a way to see the signal strength but I don't see it in the configuration. I swaped the unit with the one at a working location and it works just fine. The only thing I haven't done is try a different cable. I'm using a 100ft premade cable from Cisco.

Any help is greatly appriciated

Thanks

DKD

1 REPLY

Re: 1242AP how to check signal strength

show dot11 associations all

typically shows signal strength, and SNR along with a few otehr details when users connect.. While i have no experience with bridges, i would expect that this would have the same effect.

Hope it works for you.

412
Views
0
Helpful
1
Replies
CreatePlease login to create content