1242G and HWIC-AP-G-A client association name = hostname?
I am getting some wireless access setup on my network and noticed that the command "show dot11 associations" is displaying the hostname of the wireless access point or router rather than the actual clients name. Should'nt it be displaying the name of the client or nothing if it cannot determine the name of the client?
From an AP1242G-A hostname MYWAP: MYWAP# show dot11 assoc 802.11 Client Stations on Dot11Radio0:
SSID [MYSSID] :
MAC Address IP address Device Name Parent State ####.####:#### xx.x.xx.x ccx-client MYWAP self EAP-Assoc
2811 + HWIC-AP-G-A hostname SPARE: SPARE# show dot11 assoc 802.11 Client Stations on Dot11Radio0/3/0:
SSID [MYSSID] :
MAC Address IP address Device Name Parent State ####.####.#### xx.x.xx.xx 4500-radio SPARE self EAP-Assoc
I have tried several versions of IOS 12.4T and 15.1T they all have the same behavior. Is there anything that can be done to get them to display either the actual clients name or nothing at all? I dont like them displaying the access point hostname.
This makes our wireless monitoring software a little confusing when you see a client associated that contains the same name as the hostname of the access point the client is connected to.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...
I have created a Powershell script to automatically add a Wireless Guest
User on Cisco WLCs. (tested on 2500 Series) The script should be
completely self explanatory. Prerequisites: Powershell SNMP Module
(Install-Module -Name SNMP) SNMP Write Access to y...