Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

1242LAP with 2006 WLC

I have everything configured, but I cannot find an option to enable the radio on my 1242LAP. I don't find the option consoled in in enable mode, and I cannot find an option in the WLC.

Where do I go to turn on the radio?

2 REPLIES
New Member

Re: 1242LAP with 2006 WLC

Okay, after reading acouple of other messages, I see that the AP is only taking 4W of power, and giving me the low power source error on boot.

I am using a linksys SRW224P PoE switch to power them, capable of doing 12 ports at 15.4 W. How do I tell the LAP to ignore this error and request full power?

New Member

Re: 1242LAP with 2006 WLC

Found my answer

config ap power pre-standard enable

config ap power injector enable installed

Do that on the controller and life is good.

148
Views
0
Helpful
2
Replies
CreatePlease to create content