I am installing a point to point bridge link using 1400 briges w/power injectors. The bridges are installed but the link goes up and down about every few minutes. When it does connect, it starts out at a low dbm but eventually ends up in the 80's and then loses connection again. We installed a couple of other briges in another location and didn't have any problems at all. I know the distance between sites is way withing specs and there is nothing that could block this link. Any ideas as to what could be causing this. Thanks...
Well, there can be many reasons why this happening. First there could be some issue with the configuration specifically authentication parameters, WEP keys, role of bridge configuration and so on. If you are sure sure that the configuration on both ends of the Bridge are perfect, and if the connectivity between the bridges is intermittent the problem may be RF interference, CRC errors and so on. For more information on this read the document available at the following URL.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...