Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

1400 Series IOS Command

Does anyone know what is the command I can use to show me the signal strength of the antennas during the installation process?

What I have been doing is to do a linktest and then show log to see what happenned.  I think there should be a better way that the screen will update with all the data when there is a change in signals strength.

Thank you.

3 REPLIES
Gold

Re: 1400 Series IOS Command

If the bridges are associated then you can see the signal strength and SNR under "show dot11 assoc "

New Member

Re: 1400 Series IOS Command

What about before the bridges associated?  I'm trying to aim the antennas and if I can see whenever there is a signal strength that would be good.

Thank you

Gold

Re: 1400 Series IOS Command

If they aren't assocaited and the bridges are in Install Mode you can use the LED's

http://www.cisco.com/en/US/partner/docs/wireless/bridge/1400/installation/guide/higch3.html

397
Views
0
Helpful
3
Replies