I have a 1552eu AP which doesnt have a possibility to be connected to LAN/WAN connection. Can we convert it to autonomous and use it in Bridge mode or any other option to provide network access to clients.
WLC <--FlexConnect-> 1552 AP <--No LAN/WAN--> 1552 <--> Clients.
I don't think it would be supported as there isn't any documentation really for that. You can convert it to autonomous and try to set that up as a WGB if you want, but your best bet is really to setup one of your other AP's as a Mesh RAP and then have the 1552 mesh to that AP.
The 7500 only support FlexConnect.... so why did you purchase the 1552? You might as well just get a 2602/3602 autonomous and use that as a WGB. Like I said, you can try to load the autonomous code on the 1552 and configure that as a WGB. I don't know if you will have that option of not, because that would be a very exensive WGB.
Help out other by using the rating system and marking answered questions as "Answered"
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...