Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

1552 autonomous configuration

Setting up a couple of p2p bridges and Ive seen some basic configuration on this but nothing specific to the 1500 series. Most of the configs I have seen used Radio0 which is 2.4G I believe. Any reason not to use Radio1 which is 5Ghz? 

1 ACCEPTED SOLUTION

Accepted Solutions
Silver

Hi, The config should work

Hi,

 

The config should work for Radio1. Just change Radio0 to Radio1 in the examples you are looking at.

 

John

3 REPLIES
Silver

Hi, The config should work

Hi,

 

The config should work for Radio1. Just change Radio0 to Radio1 in the examples you are looking at.

 

John

New Member

 I am not also confirm about

 I am not also confirm about it you can view this replies on these sites also

[URL=http://freelanceforum.org/]Forums[/URL]

[URL=http://www.thefreelanceforum.com]Forums Site[/URL]

New Member

Thanks John.I just wanted to

Thanks John.

I just wanted to make sure I wasn't missing anything.

37
Views
0
Helpful
3
Replies