Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

1602E running as bridge on single antenna

Hi All,

I`m replacing a P2P bridge link currently using a couple of Cisco 1300 which are now EOL.

I`ve just got a couple of 1602E units which I`m hoping to use and i`m having trouble setting up the antenna configuration.

The current 1300 setup has a single Yaggi antenna at each end. (I`ve also had 1240AG units with a single Yaggo antenna with TX/RX both on the primary conection).

I`m trying to set the 1602Es up on 2.4ghz to just use one of the connections for the single Yaggi but every time I set the antenna from diverity to just one fo the connector (for both RX and TX) I get a web-page cannot be found and the seetings are lost.

Am I trying do do something this unit`s not capable of or am I missing some vital part of the config?

Many thanks,

Paul

261
Views
0
Helpful
0
Replies