Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

2 Buildings, 2 controllers-How to keep seperate??

I have 2 buildings with a different subnet each. I have to 4400's each with a different name but one keeps taking the other's AP's. I suspect it is because when the AP fires up it looks for that address in dns and because I have 2 buildings it has the same name but 2 different addresses.

Any way to force each one to be correct?

thanks

Gary

1 REPLY
Bronze

Re: 2 Buildings, 2 controllers-How to keep seperate??

You can manually set each AP's primary controller and secondary controller, for example, you can configure building A's AP to use WLC1 as primary controller, use WLC2 as secondary controller; configure building B's AP to use WLC2 as primary controller, use WLC1 as secondary controller, go to Wireless-->Access Points-->ALL APs-->click the AP-->detail-->High Availability to configure, refer following link for detaile:

http://www.cisco.com/en/US/docs/wireless/controller/5.1/configuration/guide/c51lwap.html#wp1249029

144
Views
0
Helpful
1
Replies
CreatePlease to create content