Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

2106 WLC Setup

Is it possible to keep everything in untagged VLANS.  I am having a heck of a time trying to get clients to get an IP address the way I have things currently setup.  Currently I have a 2106 WLC, Cisco 3560 switch, an Cisco ASA 5505, and an 1142 AP.  I can a wireless client to connect to the WLAN but i won't pass it an IP address.  I am using the ASA as a DHCP server.  Everything is on the default/untagged VLANS.  Is it possible to get this to work?

3 REPLIES
New Member

Re: 2106 WLC Setup

Hi Chad,

yes it has to work, do you configure the DHCP ip address in the interface of the SSID?

Best Regards,

Milton Tizoc.

Hall of Fame Super Gold

Re: 2106 WLC Setup

If everything is on VLAN 1, then yes.  If not then the link from WLC to switch should be a trunk (switch) and Tagged (WLC).  Access Points to switch is access port.

Hall of Fame Super Silver

Re: 2106 WLC Setup

Did you get it to work? If not, try to enter this command in the WLC CLI: config dhcp proxy disable.  Or else make the WLC a DHCP server for the wireless clients and see if that works.

-Scott
*** Please rate helpful posts ***
1024
Views
0
Helpful
3
Replies