Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

2504 controller

started configuring our 2504 controller, I connected 2504 port 1 to 3750 port, trunked with untagged management vlan 50, when I connect my pc to the switch on vlan 50 I can browse to the 2504 controller, when I try to browse to the controller from vlan 2 it doesn't connect. I do have eigrp running and the networks are defined to eigrp.

 

2 REPLIES

Are these Layer 3 VLANs or

Are these Layer 3 VLANs or SVI? If so, do you have ip routing enabled?

sh run | i ip routing

If it is a directly connected subnet it won't rely on EIGRP to route you to VLAN2.

New Member

Hey, If your question is

Hey,

 

If your question is there a limitation to access the WLC form only management VLAN PC the answer is no.

As long as you have allowed VLANs to communicate in your wired network you will be able to reach

 

Cheers,

Nour

53
Views
0
Helpful
2
Replies