Welcome to Cisco Support Community. We would love to have your feedback.
For an introduction to the new site, click here. And see here for current known issues.
i have 2504 series controller and today its stuck (before was working fine)
when i restart it (remove power and power on again) its stuck here (see in snap)
any help about this?
Go to Solution.
Contact Cisco TAC. RMA is your only answer.
Make sure you are using HyperTerminal to access the unit via the console port and use the following settings:
Bits per second: 9600
Data bits: 8
Stop bits: 1
Flow control: none