Welcome to Cisco Support Community. We would love to have your feedback.
For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.
Would someone be able to confirm that its possible to use 2 ports on the 2504 and connect each port to a separate switch for redundancy?
So i have 2 seperate switches and would like to connect port 1 on the WLC to switch 1 and port 2 on the WLC to switch 2.
Port 1 would be the primary port for management and all other interfaces and port 2 the secondary.
Code would be 126.96.36.199
Thanks in advance
Go to Solution.
Yes, this is possible. Only when you createa LAG, you cannot connect two ports into two different switches.
**** Pls rate all useful responses *****