Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

2504 WLC Not booting

Please help.

 

I have just invested in a Cisco 2504 WLC to help with my CCNA Wireless exam.

It arrived yesterday and I booted it up this morning and configured it through the wizard and a couple of 1141AP's connected and were shown in the web gui. I left it along for about 15 minutes and when I came back to it the sys light was flashing amber and the arlam light was amber.

Can't console to it or gui to get any diags.

Web docs says sys light blicking is waiting for user input which I obviously can't do as can't get to the console.

Any ideas welcome.

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Gold

If you can't console into the

If you can't console into the WLC, then go back to the vendor who sold you the WLC and get the unit RMA-ed as "DOA".
2 REPLIES
Hall of Fame Super Gold

If you can't console into the

If you can't console into the WLC, then go back to the vendor who sold you the WLC and get the unit RMA-ed as "DOA".
New Member

Hi Leo, Thanks for the reply,

Hi Leo,

 

Thanks for the reply, apologies for the delay in getting back to you.

I have done as suggested and it is on its way back and I am hoping with very crossed fingers to have my replacement by the end of the week.

 

Thanks again

130
Views
0
Helpful
2
Replies
CreatePlease to create content