Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Users might experience few discrepancies in Search results. We are working on this on our side. We apologize for the inconvenience it may have caused.

2602E wireless bridge

Hi Guys,

I will need to configure IOS (standalone) 2602E as access point as wireless bridge. When I try to disable 3 out of 4 antenna ports (only enable A) for wireless birding it won’t save I get white screen but if make changes on rest the setting I have no issues. Anyone know why is that happening?  I can make any changes expect disabling the antenna ports?

Thanks

Kumaran

3 REPLIES
VIP Purple

Re: 2602E wireless bridge

Hi Kumaran,

Follow this post:

https://supportforums.cisco.com/thread/2244263

More.......................

About your issue, you better go for Aironet IOS configuratoin guide. It is the config guide for autonomouse mode.

Check this config guide for example:

http://www.cisco.com/en/US/docs/wireless/access_point/12.4_10b_JA/configuration/guide/scg12410b.html

Check the config examples right here:

http://www.cisco.com/en/US/products/hw/wireless/ps430/prod_configuration_examples_list.html

Hope this helps.

Regards

Hall of Fame Super Silver

Re: 2602E wireless bridge

Just to add. Here is a good basic easy to follow guide for bridging.

https://supportforums.cisco.com/docs/DOC-16087

You also need to be comfortable in making changes using the CLI and not the GUI. v12.4 is more stable when using the GUI than v15.x.

Sent from Cisco Technical Support iPhone App

-Scott
*** Please rate helpful posts ***

Re: 2602E wireless bridge

400
Views
0
Helpful
3
Replies
CreatePlease to create content