Welcome to Cisco Support Community. We would love to have your feedback.
For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.
Is it possible to control the LED on a 2602i? It's too bright.
You can turn it off if that helps. Otherwise I do not think you can control light level. Here is the CLI command to do this for a given AP
(WLC3) >config ap led-state ?
disable Disables the LED-State for an AP
enable Enables the LED-State for an AP
(WLC3) >config ap led-state disable ?
all Applies the configuration to all connected APs.
Enter the name of the Cisco AP
(WLC3) >config ap led-state disable
**** Pls rate all useful responses ****
It's too bright.
Nope. You can either turning it on, off or flashing. Your choice.
Turn it off or else put one of these on the light like one of my customers did:)http://m.staples.com/touch/product.html#67076Sent from Cisco Technical Support iPhone App