I am having some difficulties trying to get a new 2702i to convert into standalone / autonomous mode.
I've done what most articles say you should do. First SSH into AP, have it pull the ios file that needs to be renamed to .default. (full name :ap3g2-k9w8-tar.default)
What happens is that the AP begins pulling from the TFTP and then restarts. However when it restarts i can not ssh back into the AP.
I see it pulls the same IP or a different IP, but i can not ssh or get webaccess into the AP. Console doesn't work at all either. I am using a usb to console cable that i know works. Here is the log upon downloading the new file from the tftp
Deleting target version: flash:/ap3g2-k9w8-mx.152-4.JB5...done. New software image installed in flash:/ap3g2-k9w8-mx.152-4.JB5 Configuring system to use new image...done. Requested system reload in progress...
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...