11-07-2003 08:54 AM - edited 07-04-2021 09:08 AM
Hi!
I've been having a problem lately with following setup: 350 AP, newest firmware, reset to defaults. 350 PC-Card, newest Software Package & Firmware.
Signal strength between 90% and 100%. Signal quality between 60% and 70%.
Problem: When I transfer data, the rate drops to 2Mbps consistently. I'm assuming when I use the bandwidth it first tries 11Mbps, then switches to 5.5Mbps and finally to 2Mbps.
I did a site survey:
1Mbps: 0 packets lost to target, 0 lost to source
2Mbps: 2 packets lost to target, 0 lost to source
5.5Mbps: 999 packets (all) lost to source, 0 to target
11Mbps: 999 packets lost to source, 0 to target
So does anybody know what's going on? I'd appreciate all help.
Regards. Igor
11-11-2003 05:23 PM
Igor,
Sounds like you have a noisy RF environment there.
On the AP do you see a lot of CRC errors and hold offs??
11-19-2003 01:59 PM
Actually, I do. When transferring data, the CRC errors increase rapidly.
Regarding a site survey test, what would be "normal" values for a site. I've set the channels according to what the manual says is the best frequency after doing the survey, but that doesn't say anything about absolute values.
Any clues?
Greetings. Igor
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide