Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

350 Bridge and Multi Point configuration

Hi, my case is a central point with 1 bridge and n° slave point.

Antennas i use are 3338 solid dish (on both sites).

In this configuration i know that the bandwith is divided into all slave point but considering type of antenna i use, i can't determine how much slave point i can realize.

I remember that with yagi antenna i can connect with a central site maximum 3 other bridges and i must place them in coverage area of this type of antenna (60° degrees - Horizontal polarization.

With solid dish?

1 REPLY

Re: 350 Bridge and Multi Point configuration

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

218
Views
0
Helpful
1
Replies
CreatePlease login to create content