Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

3560 POE problem

We are using 3560 POE switches to power Symbol AP's. All the documentation I've read says the 3560 can power up to 24 AP's. We are only able to plug in 7 to 8 AP's before some start dropping out. Is there any other possible cause for this other than lack of power?

3 REPLIES
New Member

Re: 3560 POE problem

How much power does the Symbol AP consume? Based on the 3560's data sheet, it can provide a maximum of 15.4W each for all of the 24 ports.

New Member

Re: 3560 POE problem

Based on Symbol documentation 15.4W is more than enough to power the AP. Is there a switch command to show the amount of power it is recieving from the wall/ups? The "show power" command on a 3560 works but gives no output.

New Member

Re: 3560 POE problem

if you do a "show power inline" it should give you info like this

ACADB-300C-92.3#sh power inline

Available:370.0(w) Used:109.8(w) Remaining:260.2(w)

Interface Admin Oper Power Device Class Max

(Watts)

--------- ------ ---------- ------- ------------------- ----- ----

Fa0/1 auto on 12.2 AIR-LAP1131AG-A-K9 3 15.4

Fa0/2 auto on 12.2 AIR-LAP1131AG-A-K9 3 15.4

Fa0/3 auto on 12.2 AIR-LAP1131AG-A-K9 3 15.4

Fa0/4 auto on 12.2 AIR-LAP1131AG-A-K9 3 15.4

Fa0/5 auto on 12.2 AIR-LAP1131AG-A-K9 3 15.4

Fa0/6 auto on 12.2 AIR-LAP1131AG-A-K9 3 15.4

Fa0/7 auto on 12.2 AIR-LAP1131AG-A-K9 3 15.4

Fa0/8 auto on 12.2 AIR-LAP1131AG-A-K9 3 15.4

Fa0/9 auto on 12.2 AIR-LAP1131AG-A-K9 3 15.4

352
Views
0
Helpful
3
Replies