Is the AP currently joined to a controller? If so, you can get the user name and password,
(if changed from default), from GUI>wireless>ap policies.
If nothing is set the default user name is Cisco and the password is Cisco.
Also if it is joined to a controller you will have to enable ssh and or telnet to the AP.
GUI>wireless>ap name>advanced tab>check box for ssh or telnet>apply.
If it is not joined to a controller then you just need a console cable to it and hopefully
you can know the default or previously configured credentials.
If not, then a mode button reset should get you back to Cisco/Cisco. Remove power, hold
the reset button, re-apply power and keep holding the button for 20 seconds. It should
Once you are in and in enable mode.
Debug capwap console cli
Archive download-sw /overwrite /reload tftp://a.b.c.d/imagefilename