Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

4 Regional WLCs and high availibility show command

Hi,

I have setup a global solution with 174 APs spilt over 4 Regional WLCs and all is working properly but I need to double check some configuraiton like if each AP has the correct high avalibility setup. I can do that over the GUI but I woul like to loing to each Regional WLC and by command line do something like a show ap summary that includes the high availibilty config for each AP?

Anyone knows if this command exists.?

Thank you                  

Everyone's tags (6)
1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Silver

Re: 4 Regional WLCs and high availibility show command

That information would show up in the sow run-config, but you would have to filter or just scroll to each of the ap's.  Or you can do a show ap config general .

-Scott
*** Please rate helpful posts ***
1 REPLY
Hall of Fame Super Silver

Re: 4 Regional WLCs and high availibility show command

That information would show up in the sow run-config, but you would have to filter or just scroll to each of the ap's.  Or you can do a show ap config general .

-Scott
*** Please rate helpful posts ***
256
Views
0
Helpful
1
Replies