I'm currently setting up a wirless lan with a Cisco 4402 Wireless Lan Controller and 3 cisco 1510 Access points. Everything works fine the access points discover each other and I can get from one end to the other. It's very basic no DHCP servers static IP's layer2 mode. A couple of thing are bugging about it. 1. Inside the Access Points configuration information in the web GUI it tells me the AP IP Address is disabled which is not possible because if I enter the Command Line Interface it tells me what the IP address is. It also reports it can't use the static IP address and fails back to DHCP. Everything works so I don't get what's happening here. Question 2 the service port on the fron of the 4402 is setup and telnet and SSH session are enabled on it but I can't access the interface from it. The seesion sends but doesn't receive. I could really use some specific answers to these questions. Thanks for the help.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...