I'm trying to setup a 851W router as a wireless AP and I have no previous experience, so sorry in advance if I ask dumb questions! :) I have otherwise a lot of experience with Cisco but I just started using the wireless hardware.
Basically I have a SOHO setup with a DSL modem and static IPs. FastEthernet4 is the outside and the inside network (VLAN1) is 10.100.1.x/24. I used SDM to configure the wireless portion and I can actually connect using the laptop, but I do not get a DHCP address. I would like to obtain an address from the configured pool but it doesn't work and I'm not sure where the problem is, any idea? I don't understand the whole concept about wireless configuration and bridging, etc. If someone has some links that I could look at that would be great.
Also what security do you recommend WEP or WPA, and how I do I configure them?
Here's a copy of the config, let me know if you can help! Thanks
no service pad
service timestamps debug datetime localtime
service timestamps log datetime localtime
logging buffered 65536 debugging
no aaa new-model
ip dhcp excluded-address 10.100.1.254
ip dhcp excluded-address 10.100.1.101 10.100.1.254
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...