Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Cisco Support Community site will be in read only mode on Dec14, 2017 from 12:01am PST to 11:30am for standard maintenance. Sorry for the inconvenience.

New Member

851W Wireless configuration

I've configured a 851W in order to have 1 single broadcast domain: wired and wireless client should be in the same vlan.

Client connecting to ethernet ports work fine, client connecting to Wireless are able to associate with the AP however are unable to communicate with host in the LAN.

I am used with Aironet, setting up the BVI interface, and the ethernet subinterfaces; in this circumstance, however, i have configured only the radio part, assuming there is only 1 vlan and the interface vlan would act as gateway for the hosts.

Does anybody can tell me where is the problem?

interface Dot11Radio0

no ip address

!

broadcast-key vlan 1 change 1800 membership-termination capability-change

!

!

encryption vlan 1 mode ciphers tkip

!

ssid Test

    vlan 1

    authentication open

    authentication key-management wpa

    guest-mode

    wpa-psk ascii 7 ***********

!

speed basic-1.0 basic-2.0 basic-5.5 basic-6.0 basic-9.0 basic-11.0 basic-12.0 basic-18.0 basic-24.0 basic-36.0 basic-48.0 basic-54.0

station-role root

!

interface Dot11Radio0.1

description ** WLAN **

encapsulation dot1Q 1 native

no snmp trap link-status

bridge-group 1

bridge-group 1 subscriber-loop-control

bridge-group 1 spanning-disabled

bridge-group 1 block-unknown-source

no bridge-group 1 source-learning

no bridge-group 1 unicast-flooding

!

interface Vlan1

description ** LAN **

ip address 192.168.13.254 255.255.255.0

ip nat inside

ip virtual-reassembly

1 REPLY
New Member

Re: 851W Wireless configuration

I'm not an expert in BVI configs (which I dislike) but I'd try to configure bridge-group 1 under the vlan1 interface.

1194
Views
0
Helpful
1
Replies
CreatePlease to create content