Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

857W "Unnamed Network"

Hi Gurus,

I have just setup my new 857W, I have Wireless working no problems.

But I was wondering why I have 2 "networks" that I can connect to when I go to "Connect to a network" In Vista?

I have the SSID displaying that I setup, no worries there, but I also have "Unnamed Network" as well, which is definitely coming from my router because they both disappear if I shutdown the interface - and I can also connect to it.

Have I done something wrong, or is there something I have missed?

Also have I configured this correctly using dot1q even though I only want one SSID, or is there a better way I should be doing this?

Cheers.

IOS version is 12.4(15)T1

Config:

dot11 ssid mynet

vlan 1

authentication open

authentication key-management wpa

wpa-psk ascii 7 blah

information-element ssidl advertisement wps

interface Dot11Radio0

no ip address

no ip route-cache cef

no ip route-cache

!

encryption vlan 1 mode ciphers aes-ccm

!

ssid mynet

!

speed basic-1.0 basic-2.0 basic-5.5 6.0 9.0 basic-11.0 12.0 18.0 24.0 36.0 48.0 54.0

station-role root

no cdp enable

!

interface Dot11Radio0.1

encapsulation dot1Q 1 native

no ip route-cache

no cdp enable

bridge-group 1

bridge-group 1 subscriber-loop-control

bridge-group 1 spanning-disabled

bridge-group 1 block-unknown-source

no bridge-group 1 source-learning

no bridge-group 1 unicast-flooding

2 REPLIES
Anonymous
N/A

Re: 857W "Unnamed Network"

Not sure what's happening with my name / account, apologies.

Anonymous
N/A

Re: 857W "Unnamed Network"

I worked it out - all I had to do was enable "guest-mode" on the ssid and now I do not see the "Unnamed Network".

443
Views
0
Helpful
2
Replies
CreatePlease to create content