What I have is a non-Cisco router which is connected to the internet and has a wireless.
What I want to do is set up the 871W radio interface to receive the signal from my other router (Internet) and route it(or NAT it) to the FE and WAN ports. I think this function is called something like a wireless bridge, but I am not sure.
Is it even possible to configure the radio like that? To be a receiver and send the signal to the wired ports? And how can I do this configuration?
How about if I set up the radio as a Universal Wireless Client? 871W has that mode, but I wander if in this mode I can reroute the traffic received on the radio interface to the LAN and WAN interfaces and how?
If anyone has done something like that please share.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...