Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

891 Router Wireless configuration

I read somewhere when researching this router that the built in AP could be converted to a lightweight device and controlled via a centralized controller. I am trying to figure out how to do this however I can't find any documentation stating that is supported. Does anyone have any information on this? Or does anyone have a decent example on how to configure the wireless at all?  The documentation is very sketchy

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: 891 Router Wireless configuration

Hi,

The below links will provide us the detailed explantion..

http://www.cisco.com/en/US/prod/collateral/routers/ps380/data_sheet_c78-519930.html (LWAPP support)

http://www.cisco.com/en/US/docs/routers/access/800/860-880-890/software/configuration/guide/wlan_ps380_TSD_Products_Configuration_Guide_Chapter.html (configuring the AP for autonomous mode)

>> If u need this AP module to act as a LWAPP AP then.. get into the CLI of the AP and issue the command

archive download-sw /force-reload/overwrite tftp://image

Regards

Surendra

2 REPLIES
Cisco Employee

Re: 891 Router Wireless configuration

Hi,

The below links will provide us the detailed explantion..

http://www.cisco.com/en/US/prod/collateral/routers/ps380/data_sheet_c78-519930.html (LWAPP support)

http://www.cisco.com/en/US/docs/routers/access/800/860-880-890/software/configuration/guide/wlan_ps380_TSD_Products_Configuration_Guide_Chapter.html (configuring the AP for autonomous mode)

>> If u need this AP module to act as a LWAPP AP then.. get into the CLI of the AP and issue the command

archive download-sw /force-reload/overwrite tftp://image

Regards

Surendra

New Member

Re: 891 Router Wireless configuration

Thank you, I was able to get it working now. Also if anyone chooses to do this over a VPN link you will need to adjust the

CAPWAP MSS and enable link latency in the controller. Once those settings are tuned a bit performance is very good.

1378
Views
0
Helpful
2
Replies