Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

About auto-site survey by WLSE

I've scheduled auto-site survey every sunday in the WLSE(v2.13.1).

The scheduled site-survey job is working well and logged.

But, After being surveyed, there are no changes channel and power parameter of APs.

Do i have to manually apply serveyed value to the AP by WLSE? not automatically?

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Red

Re: About auto-site survey by WLSE

Hi Kwon,

My understanding of the function was always that these surveyed values would have to be manually applied. We don't run WLSE anymore so I can't verify this for you (but I am pretty sure);

How It Works

The Auto Re-Site Survey option uses data collected from previous RM Assisted Configuration jobs to compare the current performance of the selected APs against the performance data collected the last time radio parameter generation was generated for the specified APs and applied to the specific floor. If the APs' radio performance has decreased by 20% (a user-configurable setting), a fault is generated and you are asked if you want to generate new radio parameters. The new radio parameters are compared against the existing data, and if the newly generated radio parameter yield better results, you can apply the new radio parameters to the selected APs.

Data Produced

Auto Re-Site Survey generates a fault if the radio performance of the specified floor decreases by the specified percentage. It also allows you to generate new radio parameters and apply those parameters to the APs of the specified floor.

From this WLSE doc;

http://www.cisco.com/en/US/products/sw/cscowork/ps3915/products_user_guide_chapter09186a0080527f3a.html#wp999433

Hope this helps!

Rob

2 REPLIES
Hall of Fame Super Red

Re: About auto-site survey by WLSE

Hi Kwon,

My understanding of the function was always that these surveyed values would have to be manually applied. We don't run WLSE anymore so I can't verify this for you (but I am pretty sure);

How It Works

The Auto Re-Site Survey option uses data collected from previous RM Assisted Configuration jobs to compare the current performance of the selected APs against the performance data collected the last time radio parameter generation was generated for the specified APs and applied to the specific floor. If the APs' radio performance has decreased by 20% (a user-configurable setting), a fault is generated and you are asked if you want to generate new radio parameters. The new radio parameters are compared against the existing data, and if the newly generated radio parameter yield better results, you can apply the new radio parameters to the selected APs.

Data Produced

Auto Re-Site Survey generates a fault if the radio performance of the specified floor decreases by the specified percentage. It also allows you to generate new radio parameters and apply those parameters to the APs of the specified floor.

From this WLSE doc;

http://www.cisco.com/en/US/products/sw/cscowork/ps3915/products_user_guide_chapter09186a0080527f3a.html#wp999433

Hope this helps!

Rob

New Member

Re: About auto-site survey by WLSE

Thanks. your reply.

139
Views
0
Helpful
2
Replies
CreatePlease login to create content