While the signaling rate is ~54Mbps, the actual throughput (as you have found out) is really closer to ~22-23Mbps.
You can do things like short preambles, increase the beacon times (decrease the beacon rate ... make the time between beacons longer), reduce the frag size (if you're in an environment with interference), etc ... but you are already pretty close to max.
What kind of stream description/emulation did you use with Chariot? Were you using TCP or UDP?
If you have any 802.11b clients associated, that will also negatively impact performance of an 802.11g system (it runs in "protection mode").
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...
I have created a Powershell script to automatically add a Wireless Guest
User on Cisco WLCs. (tested on 2500 Series) The script should be
completely self explanatory. Prerequisites: Powershell SNMP Module
(Install-Module -Name SNMP) SNMP Write Access to y...